Quick Start - Oregon Scientific DS6639 Guía Rápida

Connecting to PC
Please read and carefully follow the user manual for instructions on connecting
the camera to your PC or macintosh.
BASIC PHOTOGRAPHY

QUICK START

Preparing the Camera Holding the Camera
1. Slide the Mode Switch to Camera Mode. 1. Hold the
camera firmly.
2. Press and hold the Power button to
turn the camera on.
2. Avoid blocking
3. Check the battery indicator, making the lens and flash.
sure there is enough power.
3. Do not move
nor remain in
Icon Description
motion while
taking pictures.
Adequate power remains
Battery is running low
Battery is running very low.
Battery is exhausted.
4. Loop the strap over your wrist.
Taking Basic Pictures
1. Frame your subject in the viewfinder. You can also view the subject on the OSD.
2. Press the Shutter Release Button.
3. The image taken is displayed on the OSD for approximately a second (Auto
Review).
4. Once the Auto Review has finished, you may proceed to take the next picture.
When memory is full, no more images can be stored. The camera will
beep and the words "Internal Memory Full" or "Memory Card Full" will
appear on the LCD if you press the Shutter Release Button.
5. When you have finished taking your pictures, slide the Mode Switch to Off.
DS6639 Q.S.Guide-Eng/8 Lang. (086-003300- )
Selecting a Flash Mode
Inital Flash Settings
When you turn on your camera, the inital flash setting will vary depending on the
level of your battery.
Battery Status Initial Flash Setting
or The flash setting is saved after your camera is switched off
or the mode switch changes to another mode.
or The inital flash setting is
set the flash to other settings.
Toggling Between Flash Modes
Press
Press
Press
Flash Mode Options Table
Icon Function Description
Auto The flash may discharge automatically, depending on
the light conditions.
Flash On The flash discharges regardless of lighting condition.
Flash Off The flash will not discharge.
. However, you can manually