Hauck Roll A Round I Instrucciones Para El Uso página 9

INStALLAtIoN
GB
picture 1: Part list
picture : Setting it up
Set the baby walker up by grasping the upper part
of the table and pulling it up to the highest position. the height is
adjustable to 3 positions.
picture 3: Wheels
Place the baby walker upside down on a flat floor, press
the wheels with the plastic pins into the mounts until they click in. Make
sure all the wheels are firmly in place.
picture 4: install the stoppers ( sides)
4a: place the baby walker upside down on a flat floor, put the cover down to
the opening
4b: put the stopper into the cover
4c: secure the stopper by fixing 3 screws to attach with the walker base.
picture 5: operate the Stopper
the Baby walker can be fixed to the floor by
using stopper, to do this, turn the stopper to the right to fix in position,
to release the stopper, turn the stopper to the left.
picture 6: Seat attachment
to fasten the seat attachment, press the plastic
pins into the corresponding seat unit holes (6a & 6b), and lock by pressing
the pins downwards. Do check that it is firmly in place before you put your
child into the baby walker.
Picture 7: Assembly the toy compartment
there are  plastic locks on the top tray of the baby walker
which are used to fix the electronic toy compartment. Pull the  plastic
locks out and slot to the bottom of the toy compartment (7a), turn the locks
at the bottom of the top tray and fix the toy compartment securely. Use
only  x 1.5V R6 batteries, Check polarity when inserting the batteries.
Picture 8: Adjustor
the adjustor is placed underneath the top tray of the baby
walker. pull the button downward and slid the adjustor forward to adjust
the height position. Don't adjust the position when the child is inside the
baby walker.