Start-Up And Use; Switching On The Hob; Switching Off The Cooking Zones; Single Cooking Zone Operation - SCHOLTES MULTIPLO.1 F Manual De Instrucciones

Start-up and use

The glue applied on the gaskets leaves traces of
!
grease on the glass. Before using the appliance, we
recommend you remove these with a special non-
abrasive cleaning product. During the first few hours
of use there may be a smell of rubber which will
disappear very quickly.
The appliance has 2 cooking zones and its various
functions are activated by touching the
corresponding c c c c c ontrols.
Each selection must be activated within 10 seconds,
otherwise the display will switch off again.

Switching on the hob

The hob is switched on by activating the
Selecting the cooking zones
To select the desired cooking zone, press the cooking
mode selector button or
button to select the single cooking zone.
Once the desired cooking zone has been selected, set
the desired power level using buttons

Switching off the cooking zones

Activate the button; the power of the cooking
zone will progressively decrease until it is switched
off. Alternatively, activate the
buttons simultaneously; the power level will revert to
0 immediately and the cooking zone will switch off.

Single cooking zone operation

Switch on the hob. Press button
and to select the desired power level.
Once activated, press button
to switch from the single cooking zone to separate
cooking zones. It will then be possible to select one
of the two separate cooking zones.
Programming the cooking duration
! All the cooking zones may be programmed for a
length of time between 1 and 99 minutes.
button.
; alternatively press
and .
and
. Press buttons
until reaching 0
1. Select the cooking zone using the corresponding
control.
2. Adjust the power to the desired level.
3. Activate the programming button.
4. Set the desired cooking duration using the
and buttons.
5. Confirm the selection using the
indicator light corresponding to the programmed
cooking zone will start flashing.
The timer begins counting down immediately. When
the programmed cooking duration has elapsed, a
buzzer sounds (for 1 minute) and the cooking zone
switches off. Repeat the procedure described above
for every hotplate you wish to programme.
The corresponding COOKING ZONE
PROGRAMMED INDICATOR LIGHT will switch on for
every cooking zone.
When both cooking zones have been programmed,
the display visualises the remaining time for the
cooking zone with lower duration and indicates the
position of the latter with the corresponding flashing
indicator light. The indicator light for the other
programmed zone emits a steady light.
To visualise the time remaining for the other
programmed cooking zones, press button
repeatedly: the times for all the programmed
hotplates will be displayed sequentially.
Changing the programme
1. Press button repeatedly until the display
visualises the hotplate time that must be modified.
2. Press buttons and
3. Confirm by pressing button
To cancel a programme, follow the above
instructions. At step 2, press button
duration decreases progressively to 0 then turns off.
The programme resets and the display exits the
programming mode.

The timer

The hob must be switched on.
The timer allows for setting a time of up to 99
minutes.
GB
button. The
to set the new time.
.
: the
15