Tabla de contenido
Publicidad
Operating Instructions
Installation
Operation
Caution
Trouble Shooting Aurora Paper Shredders
Maintenance
Limited Warranty
Manuel de fonctionnement
Installation
Fonctionnement
Avertissement
Dépannage des déchiquteuses
à papier Aurora
Entretien
Garantie limitée
Instrucciones para operar
Instalaciones
Operación
Avertencia
Solucionar Problemas de la Máquina
Trituradora de Documentos Aurora
Mantenimiento
Garantía Limitada
Please read these operating instructions before using the unit.
Customer Service: 1 - 800 - 327 - 8508 or INFO@AURORACORP.COM
Avant d'utiliser cet appareil, Veuillez lire toutes les instructions.
Service à la clientèle : 1 - 800 - 327 - 8508 OU INFO@AURORACORP.COM
Antes de operar esta unida, por favor lea todas las instrucciones.
Servicio al Consumidor: 1 - 800 - 327 - 8508 O INFO@AURORACORP.COM
1
15 sheets of
Sheet Capacity
20lb. bond paper
Credit Card & CD Capacity
1 at a time
0.08" x 0.39" pieces
Paper Shred Size
2 mm x 10 mm pieces
Voltage
120V-60Hz 6.5A
Capacité de passage
15 feuilles de papier
à la fois
bond de 75g/m2 (20lb.)
Capacité de CD et
les introduire un par un
les cartes de crédit
en morceaux de 0.08" x 0.39"
Dimensions des déchets
en morceaux de 2 mm x 10 mm
Tension
120V-60Hz 6.5A
Capacidad de
15 hojas de papel de
destruccióna la vez
cartes de 20 libras
Capacidad de CDs y
introdúzcalos en la ranura
tarjetas de crédito
uno por uno
en pedazos de 0.08" x 0.39"
Tomaño de corte
en pedazos de 2 mm x 10 mm
Voltaje
120V-60Hz 6.5A
( U.S.A. ONLY )
( ETATS-UNIS SEULEMENT )
( LOS ESTADOS UNIDOS SÓLO )
INSTALLATION :
Carefully unpack shredder and connect the power cord to any standard 120 volt AC outlet (FIGURE 1).
Pull open the shredder door and slide in the wastebasket. After installation, make sure the shredder
door is properly closed shut. This shredder features a safety power cut off and will not operate if door
is open. Shredders with pull-out wastebaskets feature a safety power cut off upon bin removal (FIGURE 2).
Caution: MicroShred shredders have very sharp, exposed blades on the underside.
FIGURE 1
OPERATION :
POWER: Using the power button or switch, turn on the shredder (FIGURE 4).
The green light will indicate whether if the shredder is powered on.
This button turns off all features of the shredder. For safety reasons,
we recommend that you leave the shredder in the Off position
whenever the shredder is unattended or not in use.
I
O
Power On
Power Off
REV: In the unlikely event of a paper jam, the reverse setting can be used to help clear the cutters of
paper that has not passed through. Never attempt to clear a jam by using the reverse function
until you have emptied the wastebasket (FIGURE 3).
FW:
The forward setting can also be used to help clear the cutters in the event of a paper jam.
This allows to manually activate the shredder into cutting mode (FIGURE 3).
Never shred plastic (except credit cards and only by inserting them, one at a time,
through the special credit card slot), continuous forms, anything with adhesive including
labels and envelopes, newsprint, or any hard materials. While this shredder will shred
staples and small paperclips, it is recommended that you remove them whenever
possible in order to extend the life of your shredder.
FIGURE 2
FIGURE 3
FIGURE 4
continued on next page
2
Publicidad
Tabla de contenido
