Sanus CAPT01 Instrucciones De Montaje página 6

1 Install Power Center
2 Mount Thermostat
6
Make sure that the power is off . Mount the CAPT01
SANUS EcoSystem™ Multi-volt Power Supply [01] in the
upper part of the rack using four 10-32 x ¾ in. screws (not
included).
[02]
[01]
[01]
The thermostat [02] mounts to the
rack magnetically. Place it near the
top of the rack for the most accurate
operation. Plug the thermostat [02]
into the input in the back of the Multi-
volt Power Supply [01].
The thermostat [02] will control the
fans plugged into the THERMOSTAT
CONTROLLED jacks of the power
supply [01]. The fans will cycle on and
off dependent on the temperature
detected by the thermostat [02].
6901-002137 <01>