ASSEMBLY & INSTALLATION
INSTRUCTIONS
Tetsu and L'Expression Wall Mirror
INTRODUCTION
Thank you for selecting our Porcher product. To ensure that your installation proceeds smoothly, read these
instructions carefully before you begin. Also, review the recommended tools and materials section. Carefully
unpack and examine your new plumbing fixture.
To maintain the beauty of the finish, avoid placing the furniture in direct sunlight, as sunlight causes fading. Also avoid
extreme changes in temperature by arranging furniture away from radiators, heat and air vents, and air conditioning
units.Avoid placing furniture directly under windows.
ALL INSTALLATION PROCEDURES MUST COMPLY IN STRICT ACCORDANCE WITH APPLICABLE LOCAL
PLUMBING AND BUILDING CODES
Recommended Tools & Materials
Level
Roughing-in Dimensions
FIGURE 1.0
Units : Inches (mm)
27
(686)
5
(126)
FRONT VIEW
MIRROR INSTALLATION
NOTE: Where possible, try to affix to a stud or provide adequate wall support for the size and weight of the mirror.
Measure distance "D" and "D1" between mounting holes in (1) J-Rail, and distance "H" from base of Mirror to centerline of holes in (1) J-Rail.
See FIGURE 1.0
Pre-drill holes in the wall for Plastic Anchors (use when no stud is available) to the required "D" and "D1" measurement and the desired height from the floor
(preferred height of bottom of Mirror from floor + "H" for a total height). See FIGURE 1.0
Insert Plastic Anchors provided into the pre-drilled holes and secure (1) J-Rail to the wall using hardware supplied and a proper screwdriver.
Mount the Tetsu / L'Expression Mirror by hanging the (2) J-Rail affixed to the mirror onto (1) J-Rail securely fastened to the wall. See FIGURE 1.1.
P r o d u c t n a m e s l i s t e d h e r e i n a r e t r a d e m a r k s o f P O R C H E R .
© P O R C H E R 2 0 0 8
Hammer
Tape Measure
22
(559)
14
(356)
J-RAIL SYSTEM
TO HANG MIRROR
TO WALL
MIRROR
95190-00
10'
Phillips Screwdriver
1 1/4
(32)
(2) J-RAIL
FIXED
(1) J-RAIL
WALL
Ø 17
(432)
SIDE VIEW
- 1 -
Regular Screwdriver
MEASURE
"D"
D1
D1
MEASURE
"H"
CENTERLINE OF
HOLES IN J-RAIL
BACK VIEW
Drill
7 30 1 30 0 -1 0 0