CSL 301303 Manual Del Usuario página 7

Connect the cable to the main unit and to the remote unit and then switch
on the device. You can select between two different speeds for the cable
test. To test a cable test in normal speed, put the selector switch to "ON"
position. If you put the selector switch to "S" (slow), the cable test is carried
out at reduced speed. The "OFF" position switches the device off.
The measurement result is displayed simultaneously on the main unit as well
as the remote unit during the cable test. During the measurement process,
the network cable tester continuously tests the wires 1-8, and "G" addition-
ally in case of shielded cables, and indicates whether the respective wires
have contact between the connected wire ends and whether the signal is
being conducted further.
In case of a fully allocated cable with standard pin assignment and shielded
connectors, all the LED pairs should glow one after the other. If any wire is
faulty, then the corresponding LED pair does not glow.
4. Safety instructions and liability disclaimer
Never try to open the device to carry out repairs or conversions. Avoid con-
tact with mains voltages. Do not short-circuit the product. The device is not
certified for use in the open air; only use it in dry conditions. Protect it from
high humidity, water and snow. Keep it away from high temperatures. Do not
subject the device to sudden changes in temperature or heavy vibration as
this might damage electronic components. Examine the device for damage
before using it. The unit should not be used if it has received an impact or
has been damaged in any other way. Please observe national regulations and
restrictions. Do not use the device for purposes other than those described
in the instructions. This product is not a toy. Keep it out of the reach of chil-
dren or mentally impaired persons. Any repair or alteration to the device not
carried out by the original supplier, will invalidate the warranty or guarantee.
The product may only be used by persons who have read and understood
these instructions. The device specifications may change without any sepa-
rate prior notice to this effect.
7
English