American Woodmark Corporation WALL CHINA CABINET Instrucciones De Instalación página 2

THESE INSTRUCTIONS SHOULD NOT BE FAXED OR REPRODUCED ON A DIGITAL COPIER. AMERICAN WOODMARK CORPORATION PROVIDES THESE INSTRUCTIONS ON AN "AS IS" BASIS AND DISCLAIMS ANY AND
ALL LIABILITY FOR ANY INACCURACIES, OMISSIONS OR TYPOGRAPHICAL ERRORS CAUSED BY ANY THIRD PARTY'S EQUIPMENT. When you use these instructions, you are consenting to be bound by the provisions
in this paragraph. These instructions provide an illustrative method for installing American Woodmark Corporation ("AWC") cabinets and/or accessories. AWC's instructions are not intended to address every possible
contingency that might be encountered during installation or to endorse the use of any particular tools. AWC HEREBY EXPRESSLY DISCLAIMS ALL LIABILITY FOR ANY CLAIMS FOR INJURY OR DEATH RELATED TO OR
BASED UPON THE USE OF THESE INSTALLATION INSTRUCTIONS AND ANY INSTALLATION INSTRUCTIONS OTHERWISE PROVIDED BY AWC.
Installation Instructions
WALL CHINA CABINET
T-MOLDING AND DOWEL PLACEMENT
This kit allows the installation or
replacement of the T-Molding and Dowels
in WCC2415, WCC3015 and WCC3615
cabinets.
Contents
• WCC Dowels (Purchased individually or
shipped with cabinet)
• WCC T-Molding (Purchased in sets of 2
or factory installed in cabinet)
• (12) #6 x ½ " Flat Head Screws
(Factory installed in cabinet)
Tools Needed
• Phillips Screwdriver
• Safety Glasses
Removal Procedure
Remove the dowel from the
1
cabinet by lifting the dowel
up into the top T-Molding
and removing the bottom
of the dowel first. See
Figure 2.
Remove the T-Molding by
2
removing the screws. Gently
remove the T-Molding from
the groove in the cabinet.
Be sure not to lose the
screws. You will need them
later to reattach the new
T-Molding. See Figure 1.
Installation
Procedure
Place the T-Molding into
1
the groove in the cabinet
top/bottom. Be sure to use
the correct T-Molding for
the top or bottom of the
cabinet. See Figure 1.
Secure the T-Molding with
2
the screws removed in STEP
2 of the removal procedure.
Insert one end of the dowel
3
completely into the top T-
Molding and then insert the
other end into the bottom
T-Molding. The dowel
should slide down into the
bottom T-Molding without
coming out of the top
T-Molding. See Figure 2.
Read carefully before you begin installation
Top Molding
1/2"
3/8"
Bottom Molding
The holes in the top T-Molding
are deeper than the holes in the
bottom T-Molding
Figure 1
Figure 2
Figure 3
#6 x 1/2 Flat
Head Screw
(3 Per Channel)
Cabinet Top/Bottom
Top T-Molding
Dowel
Bottom T-Molding
99891 8/07