Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Safe Riding Warnings
•
Children under 14 years old, elderly, disabled people, and pregnant women are not allowed to ride the
vehicle for the safety reasons
•
People with limited sense of balance are not allowed to ride the E-scooter.
•
Avoid riding the E-scooter under the influence of alcohol or other substances.
•
Do not carry any objects while riding.
•
Make sure you have a clear vision in front of you to ride the E-scooter safely.
•
While riding, your feet must always be on the foot board.
•
The E-scooter can accommodate only one person.
•
Do not start or stop abruptly.
•
Avoid riding on steep slopes.
•
Stop riding the E-scooter if you hit against a solid object (such as a wall or other structure) with it.
•
Do not ride in dimly lit or dark places.
•
Ride the E-scooter at your own risk, we assume no liability for accidents or damage.
•
Ride at a safe speed that allows you to stop at any time.
•
Keep the E-scooter at a sufficient distance from other people and avoid collisions.
•
Steer through balance shifting, fast movement can result in falls.
•
Do not ride in rain or under other wet conditions. Ride only in dry weather.
•
Avoid riding over obstacles, if possible, and avoid snow, ice, and slippery surfaces.
•
Avoid riding over textiles, small branches, and stones, AND other possible obstacles if possible.
•
Avoid riding in narrow places or in places with obstacles, if possible.
•
Jumping on and off the E-scooter will cause damage that is not covered by the warranty. There is a risk
of injury. Injuries and damage due to «trick riding» are not covered by the warranty.
•
Do not ride in the darkness
•
Self-locking fixings may lose their effectiveness, check it carefully before the use of the e-scooter.
Charging
•
Make sure that the E-scooter, charger, and DC power input of the device are always dry.
•
To charge this E-scooter, use SOLELY the supplied XHK-800B-4220 charger with the following output:
42 V - 2 A.
•
Using a different charger may cause damage to the device and other potential risks.
•
Use the mains adapter to plug the DC input of the device into a conventional socket.
•
Make sure that the green indicator on the mains adapter is on.
•
The red indicator lights up when properly charged; if this is not the case, please check the connections.
•
If the indicator on the charger switches from red to green, the battery is fully charged.
•
Now you can stop the charging cycle. Overcharge shortens the battery life.
•
The charging process takes up to 3 hours. Do not charge the battery for more than 3 hours. After 3
hours, disconnect the charger from the device and the power supply. Overcharge reduces the battery
service life.
•
Always keep an eye on the device throughout the charging cycle.
•
Charge the device only at temperatures between 0 °C and +45 °C.
•
When charging at lower or higher temperatures, there is a risk that the battery performance will be
reduced; therefore, there is a potential risk of injuries and material damage.
•
Store and charge the device in an open, dry area away from combustible materials.
•
Do not charge the device in direct sunlight or in the vicinity of open flames.
•
Do not charge the device immediately after use. Allow the device to cool down for an hour before
charging it.
•
Do not remove the device from its package to fully charge it and then put it back in the package.
•
The device is generally partially charged as shipped from the factory. Keep the device partially charged
until it is used.
•
Allow the E-scooter to cool down for at least 1 hour before it can be put in the package.
8
Publicidad
Tabla de contenido
