Publicidad
Federal Communications Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of
the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC Caution
FCC Caution
FCC Caution: To assure continued compliance, (example - use only shielded interface cables when connecting to
FCC Caution
FCC Caution
computer or peripheral devices). Any changes or modifications not expressly approved by the party responsible for
compliance could void the user' s authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Responsible Party:
Loi Han
3715 Doolittle Drive
Redondo Beach, CA 90278-1226
U.S.A.
Telephone No:
1-310-297-5000
Federal Communications Commission Interference Statement
This equipment (Model: MRS-1200T48U) has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Note: 1) A shielded of USB interface cable with ferrite core installed on the scanner connector end must be used with this
equipment. 2) AC adapter with ferrite core installed on the scanner connector end must be used with this equipment.
Caution:
Caution:
Caution:
Caution:
Caution: Changes or modifications not expressly approved by the manufacturer responsible for compliance could void
the user's authority to operate the equipment.
Copyright © 2001 Microtek International, Inc.
Trade Name
ScanMaker 4800
FOR HOME OR OFFICE USE
http://www.microtek.com
Model Number
MRS-1200T48U
Tested to Comply
With FCC Standards
May 2001
Publicidad
