Logitech Flight System G940 Guía De Configuración página 3

Elevator Stick X Axis
Aileron Stick Y Axis
Rudder Rudder axis (slide right pedal forward during assignment)
Aileron Trim Stick Trim 2
Elevator Trim Stick Trim 1
Rudder Trim Stick Trim 3
Button Assignments:
A number of simulation controls are not assigned to buttons or keyboard commands. These controls can
be assigned to G940 buttons. To do this, click the column adjacent to the control you want to assign, and
then press the button you want to assign to it.
A Logitech Gaming Software profile is included for IL-2. Many controls are assigned there, and can be
modified to your needs.
When you are satisfied with the assignments, click "Apply". Then click back to return to the main game
menu
Falcon: Allied Force Setup Guide
Start Falcon: Allied Force
Click on "Setup"
Click "Controllers" Tab
Select "Logitech G940 Joystick" from the Flight Controller drop-down list
Move the joystick. The indicator box should detect its movement. Move the stick completely in all
directions.
Center the stick and click "Center"
Set each of the following Controls as follows:
Rudder
Select G940 Pedals from list.
Click "Detect"
Slide rudder pedals fully left and right. Pedals will be detected and move indicator.
Allow the pedals to center.
Click "Center"
Throttle
Select G940 Throttle from list
Click "detect"
Move Throttle 1; Throttle will be detected and move indicator
Position Throttle 1 at the upper detent.
Click "Set AB". This will set the point when afterburners are activated in the simulation.
Cursor X
Select G940 Joystick from list.
Click "detect"
Move upper hat switch on stick left and right