English - NUUO NV-4080 Guía Rápida De Inicio

Step 1: Unpack the Unit
This package contains the following items:
The unit
Remote control, 1.5M IR
extender cable
Disk screws
Foot pads
Power
Quick Start Guide, CD
Rackmount kit, screws
Key
*CD content: Install Wizard, Remote Live Viewer, Playback System, Backup System, Verification Tool and
Offline License Tool application, user manual, and quick start guide
Battery spec is 1.5V, AAA, R03. Two batteries are required for a remote control.
Step 2: Install Hard Drives
Refer to compatibility list and install HDDs. For optimal performance
consideration, install disks with the same model and storage capacity. The
available RAID level depends on the amount of disks installed.
Step 3: Connect the Unit and Devices within the Network
Connect the unit, cameras, and router/switch. If you need to make the
video visible over the Internet, please connect to a "router" with Internet
connection, and the unit will retrieve an IP address through DHCP by
default.
The unit processes built-in DHCP service, which takes the job of router to assign IP addresses, which is
suitable for the pure LAN environment.
Step 4: Connect the Monitor
The unit processes two display interfaces, VGA and HDMI. Connect the
monitor to the unit.
The supporting display resolutions are 1920x1080, 1280x1024, 1280x720, and 1024x768. Please confirm
that one of the resolutions is supported by your monitor.
Step 5: Connect the Power
Press the power button once connecting the power.
1bay Package
V
V
V (for 2.5" and 3.5" disk)
V
12V 4A 48W power
adapter, power cord
V
-
-
1

English

8bay Package
V
V
V (for 3.5" disk)
V
Power cord
V
V
V