Transportation And Storage; Cleaning And Maintenance - hillvert HT-HUDSON 1400B Manual De Instrucciones

2
1
Clearing the nozzle
A blocked nozzle may result in excessive pressure in the
pump and damage to the device. Clear the nozzle by
inserting a cleaning needle.
Use of detergents (model MSW-PRW2200W)
The pressure washer is designed for use with biodegradable
detergents which are environmentally friendly and protect
the device against untoward effects. Use of biodegradable
detergents will reduce the risk of the filter clogging up and
will result in longer fault-free device operation periods.
The pressure washer only dispenses detergent when
operating under low pressure. Attach the adjustable nozzle
and twist its end in „ ", direction to set the pressure
washer in low pressure mode (figure A).
Remove the cap from the detergent tank and fill it with
detergent (figure B). Do not fill the detergent tank with
water. The pressure washer will automatically mix the
detergent with water.
In order to adjust the quantity of used detergent turn the
knob (figure C) anticlockwise to reduce it and clockwise to
increase the detergent dosage.
In order to stop dispensing detergent, twist the end of the
adjustable nozzle in the
„ " direction (figure A). This will switch the device to
high pressure mode (some detergent may remain in the
high-pressure hose until it is ejected).
A
C
ATTENTION: Never use products with bleach, chlorine or
other corrosive substances, including liquids with solvents,
trisodium phosphates, ammonia or acid based cleaning
agents. These chemical agents will damage the device and
16.04.2020
EN
the cleaned surface. Always read the label of the cleaning
agent.
End of use and preparing the device for storage
• Set the ON/OFF switch to the OFF position to switch
the washer off and disconnect the device from
power.
• Cut off the water supply at source.
• Before disconnecting the high-pressure hose, point
the gun towards a safe, empty space and press
the gun trigger to release any water and pressure
remaining in the device.
ATTENTION: EXTENDED USE OF THE DEVICE WITHOUT
A WATER FEED AND AN ACTIVE PUMP WILL LEAD TO
DAMAGE.
• Disconnect the high-pressure hose from the gun and
device.
• Disconnect the garden hose from the pressure
washer (water may leak from it)
• Disconnect the quick coupler from the garden hose.
• Remove any water from the pipe by tilting the device
in different directions.
• Clean the water feed filter and re-attach
• Empty the detergent tank and rinse with water
• Activate gun safety catch
• Store the pressure washer and parts thereof in a dry
place at temperatures above 0°C.

TRANSPORTATION AND STORAGE

Shaking, crashing and turning upside down of the device
should be prevented when transporting it. Store it in
a properly ventilated location with dry air and without any
corrosive gas.

CLEANING AND MAINTENANCE

• Always unplug the device before cleaning it.
• The device features a closed lubrication system and
does not require additional lubrication.
• Inspect device parts and the high-pressure hose for
any damage regularly. If any damage is found cease
use and instruct a qualified technician to repair it.
• Check water feed filter regularly for contaminants
and clean if required.
• Use cleaner without corrosive substances to clean
surface.
B
• Dry all parts well after cleaning before the device is
used again.
• Store the unit in a dry, cool place, free from moisture
and direct exposure to sunlight.
REGULAR CONTROL OF THE DEVICE
Check regularly if the device is damaged. In case of
damage, please stop using it immediately and contact
customer service for solving the problem What to do in
case of a problem? Please contact customer service and
prepare the following information:
• Invoice number and serial number (the latter is to be
found on the technical plate on the device).
• If necessary, take a picture of the damaged, broken
or defective part.
• It will be easier for your customer service assistant
to determine the source of the problem if you give
a detailed and precise description of the problem.
The more detailed your information, the better
customer service will be able to solve your problem
rapidly and efficiently!
CAUTION: Never open the device without the authorization
of your customer service. This can lead to a loss of warranty!
13