Tabla de contenido
Publicidad
EN
v)
Do not use the device set at high volume for a long
time.
w)
Do not put the device turned on directly to your ear. It
may damage your hearing aid.
x)
Use the device parameter adjustment mode only
when the device is connected to the power supply.
y)
To avoid radio interference, it is recommended that
the Bluetooth device is used far from Wi-Fi routers,
laptops, microwave ovens and other signal sending
devices. The range also depends on the layout of the
rooms. For optimal performance, it is recommended
to place the device in a place where the walls or
furniture will not interfere.
3. USE GUIDELINES
The user is liable for any damage resulting from
unintended use of the device.
3.1. DEVICE DESCRIPTION
The loudspeaker allows you to play music in different
places. The device connects to the microphone and the
guitar. It can connect to external devices via Bluetooth,
AUX, USB, and microSD. It has a radio function. The
device is mobile thanks to castors mounted in its
bottom part. It has a telescopic handle. The loudspeaker
can also be fitted onto a stand; there is using a special
hole in the bottom of the device.
Please remember that the stand should have
adequate load capacity and be stable on a flat
surface!
CONSTRUCTION OF THE DEVICE
5
1
2
3
4
1.
Control panel
2.
Tweeter
3.
Bass speaker
4.
LED decoration
5.
Telescopic handle
FRONT AND REAR CONTROL PANEL
ATTENTION! This product's view can be found on the
last pages of the operating instructions (pp. 31).
No
Name
Funkction
FRONT PANEL
1
MODE
Press once to change the source
device (USB/ microSD, radio,
Bluetooth)
8
2
USB/
selection of the
microSD/
previous song
Bluetooth
Radio
selection of the
previous station
3
USB/
to pause or play the
microSD/BT
music again, press
and hold the button
for 2-3s
Radio
when you press the
button, the device
searches through
channels, and when
a channel is found,
its FM frequency it
automatically saved
4
USB/
select the next song
microSD/
Bluetooth
Radio
Select the next
station
5
Rec/Play
To use this button, a USB disk or
microSD card with free space must
be installed. Press the button twice
to start recording the microphone
sound. To stop recording, press the
button once again. If you then press
the button again, the device will
play the recorded sound.
6
Mic
When you press this button, the
Priority
music volume will drop when you
speak into the microphone
REAR PANEL
7
Audio
Audio input/ output
input/
output
8
Power
Switch the device on/off
9
Light/
Switch the LED lights on/off
LED
10
DC 12V
External DC 12V power supply input
Input
11
AC
AC 230V/50Hz input
Input
12
USB/
USB socket or microSD card slot (up
microSD
to 32GB)
13
Volume
Master volume
14
Bass
Bass control
15
Treble
Treble control
16
Echo
Echo intensity control
17
M.Vol
MIC volume control
18
G.Vol
Guitar volume control
19
Charge
When the battery is low, the LED
changes to red to indicate the need
to charge; When the battery is
charged, the LED is green
20
Mic
6.35mm (1/4 '') mono input to plug
input
in the microphone or the guitar
21
Guitar
6.3mm (1/4 '') guitar input
input
REMOTE CONTROL
No
Name
Function
1
POWER
Power on/off (standby mode)
2
REC:
Press to record to USB/microSD disc
3
USB/
go back to the
microSD/
previous song
Bluetooth
Radio
go back to the
previous station
4
VOL -
Volume level down
5
REPE
Replay
- pressing once replays the last song
- pressing twice replays all songs
from a selected source (USB/
microSD/Bluetooth)
6
NUMBER
Choosing a song number from USB/
microSD/Bluetooth.
To select a two-digit number, press
both numbers quickly one after
another
7
MODE
Switching between
USB/microSD/Bluetooth/LINE/FM.
8
MUTE
Press to turn off the sound
9
VOL+
Volume up
10
USB/
selection of the next
microSD/
song
Bluetooth
Radio
selection of the next
station
11
EQ
Equalization mode selection (normal,
jazz, rock, pop)
12
USB/
pause / play again
microSD/
Bluetooth
Radio
when you press the
button, the device
searches through
channels, and when
a channel is found,
its FM frequency it
automatically saved
9
EN
THE MICROPHONE
1
2
3
4
1.
Microphone cover
2.
Battery charge indicator (red LED light indicates low
battery)
3.
Power on/off and mute switch
4.
Battery and transmitter cover
3.2. PREPARING FOR USE
3.2.1. APPLIANCE LOCATION
The temperature of environment must not be higher
than 32°C and the relative humidity should be less than
85%. Ensure good ventilation in the room in which the
device is being used. There should be at least 10 cm
distance between each side of the device and the wall or
other objects. The device should always be used when
positioned on an even, stable, clean, fireproof and dry
surface, and be out of the reach of children and persons
with limited mental and sensory functions. Position the
device such that you always have access to the power
plug. The power cord connected to the appliance must
be properly grounded and correspond to the technical
details on the product label.
3.3. DEVICE USE
3.3.1 BATTERY
PLEASE NOTE: The battery must be fully charged (at least
5 hours) before the first use. The battery achieves its full
capacity only after being fully charged three times.
•
This device has a battery charging automatically
whenever the device is connected to a power
source. When charged, the device switches to
maintenance charging. Nonetheless, please do
not leave the device permanently plugged into the
socket!
•
To achieve lasting battery performance, charge
the battery before and after each use.
•
When you turn the device off with the remote
control, it is in a standby mode and uses more
energy than turned off completely by pressing
a button on the control panel.
•
When the device is left for 6 months at a low
battery level, the battery may lose its capacity
permanently. The device may heat up during
charging. Do not leave the charging device
unattended.
PLEASE NOTE: If the card will not slide in, do not force it,
just turn it over and try again.
3.3.2 CONNECTING THE DEVICE
1.
For optimal performance, position the device in the
centre of the room so that the sound is not blocked
by walls, furniture, etc.
2.
Set the main volume knob [17] on the rear control
panel to the minimum.
3.
Switch on the device [8]. The switch is on the rear
control panel.
Publicidad
Tabla de contenido
