GE HO97872 Manual De Instrucciones página 5

97872 Instructions.quark
Windows 95/98/Me/2000/NT4.0 installation
1. Connect the mouse to your computer.
2. Insert the installation diskette into your floppy disk drive.
3. Click the Start button and then click Run.
4. In the Run dialog window, type A:\setup, where "A" is the letter of your floppy disk
drive.
5. Click OK and follow the instructions on your screen to complete the installation.
The RF-Mouse ID code
Each RF-Mouse is assigned a unique ID code when manufactured, to only pick up the
signal from your mouse and prevents other RF-Mouse radio signals from operating on
your computer. This feature can also be disabled, allowing other RF-pointing devices to
operate your computer.
Connecting the RF-Mouse ID Code
When the driver installation is finished your computer
reboots and the RF-Mouse window (shown on the
right) appears.
SET ID CODE: Move the RF-Mouse for a few seconds
to establish a connection, then click Connect ID. The
unique ID code of your mouse is recognized and
another RF pointing device will not function on your
computer.
OR
EXIT: Click Exit if no other RF pointing devices are
within 3 meters range or if you want other RF pointing devices to be able to access your
computer.
2/26/02 1:25 PM Page 5
3