GYS CAP Manual De Instrucciones página 12

Operating manual
CHARGING VIA CIGARETTE LIGHTER SOCKET
To facilitate charging, the GYSCAP is supplied with a cable that can be plugged directly into the vehicle's cigarette
lighter socket. It is then possible to optimally charge the GYSCAP in approximately 30-40 min.
This is recommended for an extra charge. In case the GYSCAP is
i
completely discharged, it is quicker to connect to the battery of an
operational vehicle.
GYSCAP
Connect the GYSCAP cigarette lighter cable to a started vehicle.
The bars on the digital display increment, the GYSCAP charges:
• Recharging takes up to 30 minutes for both models.
The digital display shows "End" and "CH" simultaneously. GYSCAP is ready to be used again.
GYSCAP
The GYSCAP is charged.
Unplug the cigarette lighter socket to switch off the GYSCAP .
OPTION - RECHARGE WITH A GYSFLASH 4.12 (REF. 029422 - UK version. 029521) + Acc. Gysflash
(ref.029439)
It is possible to recharge your GYSCAP from the mains using the Supply mode of a GYSFLASH 4.12.
To enter this mode, press the GYSFLASH button for 5 seconds
selection indicators light up. After about 5 seconds, charging starts automatically (charging time: 1 hour max).
This is a one-time operation when the GYSFLASH 4.12 is used for the sole purpose of recharging the GYSCAP. If the
charger is subsequently used in another mode (e.g. to charge a vehicle), the procedure must be repeated.
USE IN STARTER MODE
For regular interventions :
Connect the GYSCAP clamps to the battery, ensure that the polarity is correct.
Press the Power button.
The digital display shows the GYSCAP voltage capacity.
Battery status display: voltage at the end of the clamps.
Press the start button. A 30 seconds countdown starts.
If the polarity is reversed, the message "Er" appears and a continuous beep sounds.
12
Translation of the original
instructions
. Once the mode is selected, the three blue mode
GYSCAP