JNF IN.28.109 Manual De Instalación página 5

Enable or disable incorrect code protection (Default: off)
7
M-CODE M-CODE
If incorrect code is enable, the system will be locked for 30 seconds aſter entering 5 our 20 times incorrect password.
Select incorrect code protection (Default: 20 times incorrect password)
8
M-CODE M-CODE
M-CODE M-CODE
Set alarm output mode (Default: disabled)
9
M-CODE M-CODE
M-CODE M-CODE
Set alarm output time
10
M-CODE M-CODE
Program the auxiliary code
11
a) Set the auxiliar code
M-CODE M-CODE
b) Select auxiliar output mode (Default: enable door open)
M-CODE M-CODE
M-CODE M-CODE
c) Set auxiliary output operating time (Default: latch mode)
M-CODE M-CODE
Restore system to factory setting.
12
Turn off the power. Put the reset jumper . Turn on the power. It's issued a beep. Turn off the power and remove
the jumper.
Manual de instalação / Installation Manual / Manual de instalación - MI084-1
*
51 #
*
53 0 #
(20 times incorrect password)
*
53 1 #
(5 times incorrect password
*
55 0 #
(0 = to disable)
*
55 2 #
(2 = to tamper switch for alarm output)
Ex. 010 (001-999 seconds)
*
#
56 "010 "
New auxiliar code (4 digits)
*
40
"AUX-CODE "
*
57 0 #
*
57 7 #
Ex. 001 (001-999 seconds)
*
58 "001 "
#
(0 = to disable)
(7 = to enable door open)
#
(000 = latch mode)
)
www.jnf.pt 5/8