Connecting To Power - TomTom WORK LINK 300 Guia De Instalacion

EN

Connecting to power

Connect TomTom LINK 300 to the vehicle
Connecting to
power
power supply with the standard vehicle
voltage (12 V / 24 V). Do not connect to a
voltage converter. The three wires GND, IGN
and PWR+ (supply voltage) must be
connected.
1. Connect the GND wire (brown) to ground
(clamp 31).
2. Fuse the PWR+ wire (red) and the IGN wire
(black) with one 2 A / fast blow fuse
(Technical data on page 25) each.
3. Connect the fused PWR+ wire (red) to the
carry current (clamp 30).
4. Then connect the fused IGN wire (black) to
ignition (clamp 15).
5. If you do not want to record digital inputs,
then connect the IN1 wire (green/blue) to
GND. If you want to record a digital input,
connect the IN1 wire (green/blue) to a 2 A /
fast blow fuse (Technical data on page 25),
then connect the fuse to a switch which is
connected to the power supply. For further
details see www.tomtomwork.com/in1.
6. Insert the 4-pin plug into the power cable
connector.
12