Ferm Industrial CDM1147P Traducción Del Manual Original página 9

When drilling in metal:
• Use a metal drill (HSS). For the best results you
should cool the bit with oil.
• Metal (HSS) drills can also be used drilling into
plastic.
When drilling in stone or masonry:
• Always use drills for concrete or masonry
drilling
• Apply force to the machine to let the hammer
action work at its best, but always make sure
the machine maintains its rotation speed.
Machine will wear out faster, and drilling will
take more time.
• When drilling pull back the drill every few
seconds. Drill dust is being removed out of the
hole and drilling is done faster.
4. MAINTENANCE
Before cleaning and maintenance,
always switch off the machine and
remove the battery pack from the
machine.
Clean the machine casings regularly with a soft
cloth, preferably after each use. Make sure that
the ventilation openings are free of dust and
dirt. Remove very persistent dirt using a soft
cloth moistened with soapsuds. Do not use any
solvents such as gasoline, alcohol, ammonia,
etc. Chemicals such as these will damage the
synthetic components.
ENVIRONMENT
Faulty and/or discarded electrical or
electronic apparatus have to be
collected at the appropriate recycling
locations.
Only for EC countries
Do not dispose of power tools into domestic
waste. According to the European Guideline
2012/19/EU for Waste Electrical and Electronic
Equipment and its implementation into national
right, power tools that are no longer usable must
be collected separately and disposed of in an
environmentally friendly way.
WARRANTY
The warranty conditions can be found on the
separately enclosed warranty card.
The product and the user manual are subject
to change. Specifications can be changed
without further notice.
9