Federal Signal NightSpire Manual Del Usuario página 15

Pairing Procedure
The search light and the controller shipped with it will be paired
as #1. If this is lost, if adding additional search lights into a
controller's memory, or if a replacement is needed, follow this
pairing procedure.
To pair the unit:
1. With the NightSpire powered down, hold the desired Preset
button for five seconds to begin the pairing procedure.
2. When the button begins to flash blue, apply power to the
search light.
3. Wait until the Power button begins to flash green and the
Preset button begins to flash red.
4. To confirm the pairing, short press the Power button. The
Preset button will turn solid green.
5. To cancel pairing and continue to scan for a new search
light, short press the Preset button. The Preset button will
begin to flash blue again.
6. Repeat this procedure for the remaining two Preset buttons
with additional search lights.
Setting the Memory
To set the memory:
1. After moving the search light into position, hold one of the
Memory buttons for five seconds until the Power button
blinks.
2. The memory is now set, and the unit can be moved to this
position by short pressing the Memory button.
Installation and Maintenance Instructions
Federal Signal www.fedsig.com
Setting up the Controller
15