Installation Steps - AVS Aeroskin Instrucciones De Instalación

Installation Steps

Use alcohol pads to clean the entire LEADING EDGE
3
5
Expose 2" (5 cm) of tape liner from each section of Aeroskin. Ensure you can access the free ends of tape liner.
FAR SIDE EDGE
free end
free end
FAR BOTTOM EDGE
NOTE: Some applications do not
6
have side tape by design.
7
NOTE: Actual application may vary slightly from illustrations.
of the hood. Let dry.
Remove and discard masking tape.
NOTE: Inspect part thoroughly to confirm all sections of tape liner are exposed.
Center the Aeroskin on the hood.
Apply surface prep to painted surface where
4
CENTER TOP
free ends
free ends
CENTER BOTTOM
Page 2 of 4
Aeroskin will attach. Let dry.
FAR SIDE EDGE
free end
FAR BOTTOM EDGE
free end