Stanley STHT0-77365 Manual Del Usuario página 3

• NEVER intentionally short any battery
terminals.
• DO NOT attempt to charge alkaline
batteries.
• DO NOT dispose of batteries in fire.
• ALWAYS remove the battery if storing the
unit for over a month.
• DO NOT dispose of this product with
household waste.
• ALWAYS check local codes and properly
dispose of used batteries.
• PLEASE RECYCLE in line with local
provisions for the collection and disposal of
electrical and electronic waste.
WARNING:
• Carefully read the User Safety and
Operating Instructions before
using this product. The person responsible
for the instrument must ensure that all
users understand and adhere to these
instructions.
WARNING:
• The following labels are placed on the laser
tool to inform you of the laser class for your
convenience and safety.
OPERATING INSTRUCTIONS
BATTERY
Open the battery door on the handle of unit
and connect 2 AAA (1.5 V) batteries, ensuring
polarity is correct per the indication on the
inside of case. Replace battery door. It is
recommended to replace the batteries with
new batteries when battery indicator shows .
USAGE
1. Point the IR Thermometer at the object
to be measured, pull and hold the
trigger. When the IR thermometer is in
measurement mode the LCD backlight
will illuminate and the laser will be on, the
measurement indicator "SCAN" icon will
also be displayed on the LCD.
• When the trigger is released 3 audible
beeps will sound and the laser will shut off;
the last temperature reading will remain
on the LCD. After 15 seconds the LCD
backlight will turn off and after 1 minute the
IR Thermometer will turn off.
2. When the IR Thermometer is in the "ON"
state (trigger is not pulled), pressing the
button will select the desired unit of
measure: C° or F°.
3. When the IR Thermometer is in the "ON"
state (trigger is not pulled), pressing and
holding the button for about 3 seconds
will turn the unit off.
4. When the IR Thermometer is in the
measurement mode (trigger is pulled and
held), pressing the
reference temperature.
5. Press the button to select the desired
temperature threshold (0.5°C/1°F, 3°C/5°F,
or 5.5°C/10°F). The
current setting.
• To disable the threshold feature, press the
button until the
"OFF" mark.
6. Once a reference temperature and
temperature threshold are set the unit
can be used to scan areas for changes in
temperature. While in measurement mode
the backlight will be green and "NORMAL"
º C/ º F
SET
OFF
OFF
OFF
button will set the
icon indicates your
icon is over the
º C/ º F
SET
3