WELDY HG 330-B Manual De Operación página 5

Ocultar thumbs Ver también para HG 330-B:
Tabla de contenido

Publicidad

Important safety instructions
This appliance has a polarized plug (one blade is wider than the other). To reduce the risk
of electric shock, this plug is intended to fit in a polarized outlet only one way. If the plug
does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified
electrician. Do not modify the plug in any way.
Hidden areas such as behind walls, ceilings, floors, soffit boards and other panels may
con-tain flammable materials that could be ignited by the heat gun when working in these
loca-tions. The ignition of these materials may not be readily apparent and could result in
property damage and injury to persons.
When working in these locations, keep the gun moving in a back-and-forth motion. Lingering
or pausing in one spot could ignite the panel or the material behind it.
Read these instructions
Warning: Extreme care should be taken when stripping paint. The peelings, residue and
vapors of paint may contain lead, which is poisonous. Any pre-1977 paint may contain
lead and paint applied to homes prior to 1950 is likely to contain lead. Once deposited on
surfaces, hand to mouth contact can result in the ingestion of lead. Exposure to even low
levels of lead can cause irreversible brain and nervous system damage; young and unborn
children are particularly vulnerable.
Before beginning any paint removal process you should determine whether the paint you
are removing contains lead. This can be done by your local health department or by a
professional who uses a paint analyzer to check the lead content of the paint to be removed.
LEAD-BASED PAINT SHOULD ONLY BE REMOVED BY A PROFESSIONAL AND SHOULD
NOT BE REMOVED USING A HEAT GUN.
Persons removing paint should follow these guidelines:
1. Move the work piece outdoors. If this is not possible, keep the work area well ventilated.
Open the windows and put an exhaust fan in one of them. Be sure the fan is moving
the air from inside to outside.
2. Remove or cover any carpets, rugs, furniture, clothing, cooking utensils and air ducts.
3. Place drop cloths in the work area to catch any paint chips or peelings. Wear protective
Original Operating Manual
clothing such as extra work shirts, overalls and hats.
4. Work in one room at a time. Furnishings should be removed or placed in the center of
the room and covered. Work areas should be sealed off from the rest of the dwelling
by sealing doorways with drop cloths.
5. Children, pregnant or potentially pregnant women and nursing mothers should not be
present in the work area until the work is done and all clean up is complete.
6. Wear dust respirator mask or a dual filter (dust and fume) respirator mask which has
been approved by the Occupational Safety and Health Administration (OSHA), the
National Institute of Safety and Health (NIOSH), or the United States Bureau of Mines.
These masks and replaceable filters are readily available at major hardware stores.
Be sure the mask fits. Beards and facial hair may keep masks from sealing properly.
Change filters often. DISPOSABLE PAPER MASKS ARE NOT ADEQUATE.
7. Use caution when operating the hot air tool. Keep the heat gun moving as excessive
heat will generate fumes which can be inhaled by the operator.
8. Keep food and drink out of the work area. Wash hands, arms and face and rinse mouth
before eating or drinking. Do not smoke or chew gum or tobacco in the work area.
9. Clean up all removed paint and dust by wet mopping the floors. Use a wet cloth to clean
all walls, sills and any other surface where paint or dust is clinging. DO NOT SWEEP,
DRY DUST OR VACUUM. Use a high phosphate detergent or trisodium phosphate (TSP)
to wash and mop areas.
10. At the end of each work session put the paint chips and debris in a double plastic bag,
close it with tape or twist ties and dispose of properly.
11. Remove protective clothing and work shoes in the work area to avoid carrying dust
into the rest to the dwelling. Wash work clothes separately. Wipe shoes off with a wet
rag that is then washed with the work clothes. Wash hair and body thoroughly with
soap and water.
SAVE THESE INSTRUCTIONS
DE
EN
IT
FR
ES
PT
NL
HY
TH
ZH
JA
MN
AR
FA
KO
5

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Hg 330-sHg 330-aHg 530-sHg 530-a

Tabla de contenido