Publicidad
Idiomas disponibles
Idiomas disponibles
Vacuum any metal shavings created during the drilling process from inside the tailgate
Remove lights (if equipped) from factory cover panels and install into the speaker baffle.
Note: Lights are keyed and can only be installed one way. Do not force light into
speaker baffle incorrectly.
Connect the controller to the amplifier and secure by turning locking ring until finger tight. Fig 14
Connect the 1/8-inch jack to the amplifier. Fig 14
Connect the USB cable to the amplifier and secure to the metal tab with supplied wire tie. Fig 15
Connect the speaker wires to the speakers. Fig 16
Note: There are two different size connectors. Make sure the large connector is
connected to the large speaker terminal and the small connector is connected
to the small speaker terminal.
Note: Make sure the speaker terminals are properly inserted into connectors. It is
possible for the speaker terminal to be inadvertently inserted between the
metal connector and the plastic insulator.
Secure extra controller cable with wire ties. Fig 17
Note: Trim wire tie ends. Make certain there are no loose ends of wire ties or wires
that can contact the plastic housing or the tailgate in order to prevent buzzes or
rattles from vibration.
Fig 14
Fig 16
Fig 15
Fig 17
6
Publicidad
