Philips AWP3703/10 Manual Del Usuario página 11

Notes
The actual lifespan of the filter cartridge depends on the local tap water quality and
daily usage. If significant lower flow rate is observed, please replace the filter cartridge.
Replacing the filter cartridge
A. Turn off the faucet
B. Take off the filter housing
C. Insert a new filter cartridge into the holder and put the housing back. Please check
if the seal ring is in place, and if it's damaged.
D. Set the timer.
E. Let the water run for 5 seconds under the
filtered mode.
D1-1
3. Precautions
Warning
- Always use municipal tap water as the water source. Do not use with water that is
microbiologically unsafe or unknown quality without adequate disinfection before or
after the device.
- Do not install this device on a water supply line with a water pressure exceeding
0.35 MPa. If the inlet water pressure exceeds 0.35 MPa, a relief valve must be installed
(purchased separately).
- The water temperature for the filtration mode should be between 5-38°C. If the inlet
water temperature exceeds 38°C, the filter will be damaged. If the inlet water
temperature is lower than 5°C, it may cause freezing and water leakage.
- Do not reverse the installation order.
- This device is intended for domestic use only.
D1-1 D1-2
D1-2
4
mode, and 3 minutes under the