Safety Inspection - AC Hydraulic WT1500 Manual De Instrucciones

WT1500
GB
WARNING -
safe usage instructions
1. Study, understand and follow all instructions before
operating this device.
2. Do not exceed rated capacity.
3. Use only for wheel lifting, and only on hard level
surface.
4. Always support the vehicle with support stands
before using the wheel trolley.
5. Apply the wheel as far in on the rollers as possible.
6. Assure that the load cannot tilt while lowering or
moving.
7. Verify that the surface is free of obstacles before
lowering, and that there is no risk of pinching
between moving parts.
8. Lower the wheel and secure it with the wheel
support before transporting.
9. Only original accessories and spare parts shall be
used.
10. No alterations shall be made to this device.
11. Failure to follow these warnings may result in
personal injury and/or property damage.
Assembly
1. Mount the 2 pivotal wheels (4 + 5) with screws
M10x20 (44) and nuts (52).
2. Remove cover (28).
3. Remove front (30) and rear (31) cover.
4. Mount the chain (15) on chain wheels (18 + 19)
and adjust chain tensioner (16). Then grease the
chain.
5. Take screw M8x60 (61) through the tower, mount
distance tube (32) together with cover for spindle
(29) and tighten with nut (51).
6. Remount covers (28 + 30 + 31).
7. Fix handle (17) on axel (57) using screw M6x12.
8. Mount bracket (23) on frame with 2 screws
M10x30 (64) and washer (58), without tightening.
9. Put 4 disc springs (40) in each end of the roller
assembly, 2 by 2 against each other.
10. Mount the roller assemblies and tighten screws
(64). If need be adjust roller position using M16
nuts (50).
11. Mount claw (55) on inner tube (62) with screws
M8x25 (60) and washers (35). Lift inner tube into
outer tube (22).
12. Mount outer telescopic tube (22) on frame with 4
screws M8x25 (60) and washers (35).
13. Install wheel support (46) in claw (55).
Use
WARNING: The wheel trolley is for lifting wheels only
– not for lifting vehicles!
Wheel size: Adjust distance between lifting arms by
turning the handle.
Lifting: Centre the wheel removal trolley around the
wheel and as far in on the rollers as possible. Then
operate the handle clockwise.
Lowering: Turn the handle counter clockwise.
Transport: Before transportation, lower the wheel, and
secure with the wheel support. Adjust wheel support
with handles (27) and (56).
Maintenance
Maintenance and repair must always be carried out by
qualified personnel.
Cleaning: We advice not to use high pressure cleaner,
steam jets or degreasing agents in order to avoid
degreasing and penetrating water. If not mechanical
parts must be lubricated afterwards.
Daily: Check the wheel removal trolley for damages.
Monthly: lubricate axles and rollers with grease or high-
quality oil.

Safety inspection

According to national legislation – minimum once
a year though – the wheel removal trolley must be
inspected by an expert: frame, rollers and wheel
support for fatique and wear; greasing and oiling in
general. Also inspect greasing and tension of chain.
Finally that all safety labels are legible.
Trouble shooting
The trolley cannot lift or lower: inspect the chain by
removing cover (30). Chain tension is adjusted by the
chain tensioner (16).
Spare parts
Replace worn or broken parts with genuine jack
manufacturer supplied parts only. All major parts may
not be provided after discontinuation of the model.
Scrapping
We recommend recycling when the trolley is to be
scrapped.