Park Tool CM-5 Guia De Inicio Rapido

Park Tool Co.
6 Long Lake Rd. St. Paul, MN 55115 (USA) www.parktool.com
Before You BegIn
Slide handle up firmly into body of Cyclone. Place newspaper
or other floor protection under work area. Remove excess
mud, dirt and sand from chain and other components with
Park Tool GSC-1 GearClean Brush or rag. Shift to smallest rear
cog. Shift to chainring or tilt bike in stand to make lower section
of chain horizontal.
To uSe
1. Attach Cyclone around lower section of chain as shown.
2. Fill with cleaning fluid to fill line.
3. Crank pedals backwards 30 revolutions.
4. Empty Cyclone and rinse with water. Squeeze fluid from sponge.
5. Repeat steps 1 - 4.
6. Dry and then lubricate chain.
TIpS
• Water and a small amount of dishwashing detergent may
be substituted for cleaning fluid.
• Replacement brushes and sponges are available. Ask your
favorite bike retailer for Park Tool part RBS-5.
CauTIon
• Park Tool CB-2 Citrus ChainBrite Chain Cleaning Fluid is
recommended.
• Do not use gasoline, petrol, kerosene or other highly
volatile or flammable solvents.
• Do not store cleaning fluid in Cyclone.
• Dispose of spent cleaning fluid responsibly.
Sidewall Brush
Assembly 323
Cyclone Chain Scrubber CM-5
Roller Brush
324-2A
Wicking Sponge
Magnet 330
Instructions for
1
2
3
329
Spring Lock
326-2
FILL C CLONE
Chain Scrubber
CM-5
FILL C CLONE
Chain Scrubber
CM-5
C CLONE
Chain Scrubber
GSC-1 GearClean Brush
(not included with CM-5)
® The color BLUE is a registered trademark and trade dress of Park Tool Co.
© 2008 Park Tool Co.