Deuba DBWH003 Manual Del Usuario página 11

Lifting the load:
Close the unloading valve by turning it clockwise. Position the jack under the load so that the
load receptacle is firmly connected to the load. Center the load so that it can no longer slip. Press
the handle of the jack until the load receptacle reaches the load. Check again whether the load
receptacle is still positioned correctly. Raise the load to its desired height. Make sure that the jack
does not lift more than the maximum load capacity. Do not crawl under your vehicle while the
vehicle is being lifted or the supports are being moved. Place the supports only in the locations
intended by the vehicle manufacturer so that the vehicle being lifted is actually supported and
secured.
Lowering the load:
Open the relief valve very slowly (turn counterclockwise. The load support is lowered when the
relief valve is open. Only lower the vehicle very slowly so that the load and the supports are not
shaken. If the jack has ever been repaired, raise the vehicle only until you can remove the
supports. Then lower the vehicle very slowly.
Slowly turn the lever section counterclockwise to lower the jack to its lowest point.
11 www.DEUBAXXL.de