Traxxas ATON 7971 Guia Del Usuario

Camera/Gimbal Mount Assembly Instructions
Kit contents:
• Upper mount half
• Lower mount half
• Rubber isolators for fixed camera bracket mount assembly (4)
• Rubber isolators for 2-axis gimbal mount assembly (4) (marked with yellow dot)
• Fixed camera bracket
• 2.6x8mm button-head cap screw (1)
Mount Assembly for use with fixed camera bracket
A B
2
C
No yellow dot
Traxxas, 6250 Traxxas Way, McKinney, TX 75070, Phone: 972-549-3000, Fax: 972-549-3011, e-mail: support@Traxxas.com
4
3
Fixed camera
installed on
1
Final Assembly
Tools required:
• Needle nose pliers
Mount Assembly
1. Slide the upper mount half under the lower mount half (A).
2. Flex the upper mount half to align the eyelets above the lower mount half eyelets on
each corner of the mount (B). Refer to Figure B for the order of eyelet alignment (1-4).
3. Use needle nose pliers to install the rubber isolators into the eyelets on each corner
between the two mount halves (C).
Mount Assembly for use with 2-axis gimbal
A
bracket
mount
C
Yellow dot
T R AXXAS. com
Covers Part #7971
B
4
3
2
1
Final Assembly
KC2361-R03
2-axis gimbal
installed on
mount
Rev 160210