Installation Under Windows - ELSA TanGo 1000 Guia De Instalacion

Installation

Installation under Windows

Depending on the version which you are using, Windows 95 presents one of two
possible procedures for the installation. Exactly which version you have will become
clear according to the message which appears after the
restarted.
Possibility 1:
After connecting the ISDN terminal adapter , your computer must be restarted.
®
Windows 95 displays the "New Hardware Found" window with the message
that the ISDN terminal adapter has been recognized as ELSA TanGo 1000 .
Select the Driver from disk provided by hardware manufacturer option
and click on OK . The window "Install from Disk" is displayed.
Insert the CD supplied into the CD-ROM drive and click on Browse . The
"Open" window is displayed.
Change to your CD Rom drive (e.g. d:\) and click on OK .
Select the ISDN terminal adapter ELSA TanGo 1000 under the window "Select
model" and confirm with OK . The required files will now be copied onto the
hard disk.
In the "Control Panel" under "Modems", your ISDN terminal adapter should be
correctly displayed under "Properties for Modems".
Possibility 2 (Windows 95 Service Release 2):
After connecting your ISDN terminal adapter, your computer must be
restarted. Windows 95 displays the "New Hardware Found" window followed
by the "Update Device Driver Wizard".
Insert the CD supplied into the CD-ROM drive and click on Next . After the
drivers have been found click on Next . The "Update Device Driver Wizard"
appears again with the message "Windows found the following updated driver
for this device: ELSA TanGo 1000 ".
Continue with Next . The files required will now be copied.
In the "Control Panel" under "Modems", your ISDN terminal adapter should be
correctly displayed under "Properties for Modems".
®
95
computer has been
7