Unpacking; Assemble Wheels; Assemble Rubber Feet - Craftsman 919.166700 Manual Del Usuario

THE WHEELS AND HANDLE
DO NOT PROVIDE ADE-
QUATE CLEARANCE, STABILITY OR SUPPORT
FOR PULLING THE UNIT UP AND DOWN
STAIRS OR STEPS. THE UNIT MUST BE LIFT-
ED, OR PUSHED UP A RAMP.
It may be necessary to brace
or support one end of the
outfit when attaching the wheels and the rubber
feet, because the air compressor will have a ten-
dency to tip.
1. Place shoulder bolt (C) through wheel (B) and
position it into the hole of the mounting bracket
(protruding hub to the inside). Thread nut (A)
onto shoulder bolt and tighten firmly with a
9/16" wrench. Repeat to install second wheel.
D
E
D23012
All manuals and user guides at all-guides.com
C
A
B
2. Attach the rubber feet (D) to the bottom of the
front bracket using the screws (E) provided.
3. Rotate handle into operating position as shown.
NOTE: Handles will lock into place.
8 - ENG