Tabla de contenido
Publicidad
Lector de tarjetas magnéticas MiCard
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
•
•
•
•
IC Compliance Notes (for Canada)
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
For models with integrated RFID functionality:
This device complies with Industry Canada licence-exempt RSS standard(s). Operation
is subject to the following two conditions: (1) this device may not cause interference,
and (2) this device must accept any interference, including interference that may cause
undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit
accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible
d'en compromettre le fonctionnement.
Información para los usuarios sobre la eliminación de residuos de aparatos
eléctricos y electrónicos (WEEE)
El símbolo WEEE en el producto y/o los documentos que lo acompañan significa que
los equipos eléctricos y electrónicos usados no se deben mezclar con los residuos
domésticos generales. Para su correcto tratamiento, recuperación y reciclado, lleve
este producto a los puntos de recogida designados, de acuerdo con la legislación
nacional y la Directiva 2012/19/UE.
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment to an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
7
Publicidad
Tabla de contenido
