Adjusting The Clipping Pressure - Swiss Made Xplorer/C Traducción Del Manual Original

6.5

Adjusting the clipping pressure

Fig. 8
NOTE!
If the clipping pressure is too low, hair can gather between the
X X
clipping blades. This results in a poor clipping quality. In this
case, clean the clipping blades as described in chapter 6.10.
14
approx. 30 % battery charge
approx. 75 % battery charge
approx. 90 % battery charge
Deep discharging
If the battery is deeply discharged the bottom LEDs
lights up green. The charger will attempt to charge
the battery. If after a short while the voltage has not
increased, the display shows "Battery defective".
If the voltage has increased, normal charging starts.
Defective battery
If the battery cannot be charged or is defective,
the top LED flashes red.
Set the clipping pressure as follows be-
fore you start clipping:
Turn the adjusting knob in the direc-
X X
tion of the arrow until you feel resis-
tance.
Turn the knob another 1/4 turn in the
X X
direction of the arrow.
If the clipping quality deteriorates,
X X
increase the clipping pressure by
turning the adjusting knob another
1/4 turn in the direction of the arrow.
If this does not produce the desired
result, the blades must be replaced
or sharpened.
Instruction Manual / Cattle and Horse Clipper