Hinkley 980010FAW Instrucciones De Instalación

PLEASE DO NOT USE FAN CONTROL WITH DC FANS
BE SURE TO FOLLOW ALL STEPS IN THE ORDER GIVEN.
BE SURE POWER IS OFF AT FUSE, OR CIRCUIT BREAKER BOX.
WARNING: 1.25 Amp - Multiple Speed Control
Maximum Current Consumption of 1.25 Amps.
NOTE: Set fan on its "HIGH SPEED" pull chain setting
before using the wall control.
WARNING: To avoid fire, shock and serious personal
injury, follow these instructions:
A. Read your owner's manual carefully, retain owner's
manual for future reference.
B. To avoid possible electrical shock, be sure
electricity is turned off at the fuse box or circuit
breaker panel before wiring.
C. This switch is designed for ceiling fan only, to avoid
overheating and possible damage to other
equipment, do not install to control receptacle,
fluorescent lighting fixture, motor - operated
appliance, transformer-supplied appliance or near
heat source.
D. All wiring must conform to national and local
electrical codes. If you feel you do not have
enough electrical knowledge, have a licensed
electrician install the control.
E. Total amperage and/ or wattage for your fan should
not exceed 120 Volts, 60 HZ, 1.25A (Max.)
1. Turn power OFF at fuse box or circuit breaker and
remove the existing wall plate and switch, do not
remove wires before noting their position. (Figure 1).
2. Make wire connections (Figure 2) and secure with
wire nuts supplied.
● Connect the black wire from the fan to black wire
from the wall control.
● Connect the white (neutral) wire from the ceiling to
the white wire from the fan.
● Connect the black (hot) wire from the ceiling to the
black/white wire from the wall control.
● If your outlet box has a ground wire (green or bare
copper) connect the wall control's ground wire to
it; otherwise connect the wall control's ground wire
directly to one of the screws from the outlet box.
3. Attach the control to the outlet (wall) box and secure
with 2 outlet box screws (Figure 3).
For Warranty Information please visit www.hinkley.com
3 SPEED CEILING FAN
INSTALLATION INSTRUCTIONS
READ AND SAVE THESE INSTRUCTIONS
Outlet box
Fig. 1
Hot
Black
Black/
White
120 VAC
60Hz
Green/
Ground
Wall control
Neutral
White
Fig. 2
Outlet box
Fig. 3
WALL CONTROL
Model: 980010FAW
Switch
Wall plate
Black Black
White
Fan
Wall control
Screws