Troubleshooting; Specifications - ASA Electronics ASABG6 Manual Del Usuario

TROUBLESHOOTING

Problem
Power amplifier light is
not ON
No sound
Engine noise from the
horn
Distortion
Protection indicator's
red light is ON
No short circuit when
the protection indicator's
red light is ON
Hoarse / raspy sound
Sound field (Phasing)

SPECIFICATIONS

Operating Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12VDC
Quiescent current. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1.7A
Effective Output Power @14.4V/ 4Ω . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 45 Watts, 6 Channels
Maximum Output Power . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .. . . . . . . . . . . . . . . . . 480 Watts Total
Frequency Response . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10Hz – 20KHz
Distortion . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ≤0.1%
Input sensitivity . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2V
Signal Noise Ratio . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . >95dB
Fuse Rating. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 40A x 1
Dimensions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .8.5" x 6" x 1.7"
Mounting Dimensions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7.9" x 5.3"
Weight . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3.2 lbs
Specifications are subject to change without notice.
Table 2: Troubleshooting
Check the controlling voltage of the main engine.
Check the positive terminal.
Make sure the power amplifier is properly installed.
Check the fuse.
Check the voltage of the power supply and amplifier.
Check the connection between the power amplifier and the speaker.
Check the audio output between the host and the amplifier.
Check the connection between the amplifier and the speaker.
Turn off the power source and unplug the audio output connector. Check the devices and the
connecting cables of the amplifier.
Check the DSP profile setting.
Make sure the amplifier is installed in a well-ventilated location.
Check the connection impedance of the loud speaker.
Check whether the speaker crossover is short circuited.
Check whether the speaker wire of the power amplifier to the speaker is short-circuited.
Check condition of speaker voice coil.
Check whether the positive and negative terminals of the loudspeakers are connected
correctly.
Solution
6
ASABG6