Sauder LITTER BOX CAT CUBE TOWER Manual Del Usuario página 21

Step 16
Carefully stand your unit upright against the wall in its fi nal location.
å
The following instructions show your unit being fastened to a wall stud. If you are not fastening your unit to a wall stud,
å
go to the next step now.
1 - Locate the center of a stud in your wall near your unit and mark it with a pencil.
st
å
2 - Drill a 1/8" hole on the mark and into the stud in your wall.
nd
å
3 - Fasten the unit to the wall. Use the LONG SCREW through the other end of the SAFETY STRAP and into the 1/8" hole.
rd
å
Mark and drill
a 1/8" hole into
the wall stud.
1
st
96
www.litterbox.com/support
Electric drill with 1/8" bit
2
nd
3
rd
427150 Page 21