Cisco Systems Catalyst 2960 Serie Guía De Inicio página 8

Running Express Setup
Equipment That You Supply to Run Express Setup
Running Express Setup
Verify that no devices are connected to the switch, because during Express Setup, the switch
Step 1
acts as a DHCP server. If your PC has a static IP address, before you begin, you should change
your PC settings to temporarily use DHCP.
Connect the AC power cord to the switch and to a grounded AC outlet. The power-on self-test
Step 2
(POST) begins. During POST, the LEDs blink while a series of tests verify that the switch
functions properly. LED behavior during POST is unpredictable and might vary.
Wait for the switch to complete POST. It might take several minutes for the switch to complete
Step 3
POST.
Verify that POST has completed by confirming that the SYST LED rapidly blinks green. If the
Step 4
switch fails POST, the SYST LED turns amber.
POST errors are usually fatal. Call Cisco Systems immediately if your switch fails POST.
Catalyst 2960 Switch Getting Started Guide
1-2
You need to supply this equipment to run Express Setup:
PC
•
Ethernet (Category 5) straight-through cable (as shown)
•
When you first set up the switch, you should use Express Setup to enter the initial
IP information. This enables the switch to connect to local routers and the
Internet. You can then access the switch through the IP address for further
configuration.
To run Express Setup:
Chapter 1 Getting Started Guide
78-16879-02