Care And Maintenance - ROMPA 15410 Manual De Instrucciones

13. Installation
1. Unpack.
2. Ensure the diffuser is disconnected from mains supply before fitting the cartridge.
Remove the cartridge from its bag. Apply one or a couple of drops of essential oil to
the cartridge.
3. Gripping the cartridge by the main rib on its underside, insert into the base by
aligning tabs and turning clockwise until cartridge locks into position.
4. Place unit on a flat, stable surface that does not obstruct airflow into the base.
5. To operate, connect to mains supply (plug in) and switch on. Choose 'I' or 'II'
according to intensity required.
14. Care and Maintenance
• With most essential oils only a single drop is required on one segment of the
cartridge. You can mark this segment on the edge of the cartridge so the same
segment can be used with the same oil each time. Different oils may be applied to
other segments.
• To change oils simply run the diffuser until the fragrance of the existing oil has
passed then apply another oil to the cartridge. Alternatively a separate cartridge
may be used for each oil.
• Oils may be mixed to your own taste by either putting more than one oil on the
cartridge at any one time, or blending oils before they are applied.
• To save any unspent oil on the cartridge after use simply store in self‐sealing bag
provided
15. Troubleshooting
Not applicable
Further copies of these instructions can be downloaded at www.rompa.com
We hope you find our instructions invaluable. If you have any suggestions for improving
them further your comments will be greatly received – please contact us at
producthelp@rompa.com
AROMA DIFFUSER PROFESSIONAL, February 2013
Copyright ROMPA®Ltd