KODA SW800 Manual De Instrucciones página 4

Connections via High Level Inputs
If your amplification system has a dedicated subwoofer line output, you should
connect this subwoofer via the line input on the rear panel via a good quality
phono lead. Note that if your amplification system has a mono subwoofer line
output, use the LEFT/MONO socket on this subwoofer.
Recommendations
Do not compromise the performance of your system by using inferior quality
cables. It is recommended to use high quality cables of 16 AWG/1.3mmØ or
higher. Please ask your dealer for advice.
Observing polarity is of the utmost importance while connecting your
loudspeakers. Ensure that the red (+) terminals on your amplification system are
connected to the red (+) on the subwoofer and the black (-) on your amplification
system to the black (-) on your subwoofer.
Important Note
Always unplug all AC powered components before making any loudspeaker
component connections. This will avoid the risk of electric shock or damage of
your equipment.
Running in
Your new unit will require a total of approximately 10 hours of normal use to
allow the components to settle into their working routine and reach their
optimum performance.
Positioning your subwoofer
The positioning of your subwoofer will affect the quantity and also quality of the
lower frequencies of the system. Locating the subwoofer near a wall will increase
the bass response of the speaker; If it is placed too near to a corner however, the
overall effect may be too 'boomy'. Due to the low frequency modal
characteristics of the room, the response will change as it is placed a little closer
or further away from the listening position. Adjusting the rear panel controls (as
explained in previous sections) will also affect the sound, so the answer is to
experiment and find the position and settings that provide a good balance
between low frequency amount and definition across a range of source material.
©Copyright Lotronic 2014
Care of your subwoofer
Cabinets should be dusted and lightly polished as required. Don't use solvent
based cleaners as they may damage the cabinet surface. Don't expose the
cabinets to strong, direct sunlight, high temperatures, high humidity or allow
them to become wet.
Specifications
Output power ................................................................................100W
Impedance................................................................................... 4 Ohm
Frequency response ......................................................... 50Hz – 200Hz
Sensitivity ............................................ Line in: 500mV (at max. output)
.......................................................... High level in: 8V (at max. output)
Input voltage ...................................................... 220 – 240Vac 50/60Hz
Consumption .................................................................. 240W (4 Ohm)
Driver ..................................................... Unshielded long-throw woofer
Dimensions .............................................................. 324 x 300 x 300mm
Net weight ......................................................................... 10.9kg/24lbs
IMPORTANT NOTE: Electric products must not be put into household waste.
Please bring them to a recycling centre. Ask your local authorities or your
dealer about the way to proceed.
4