TechGrow PRO Serie Manual De Usuario página 9

Operating and adjusting the TechGrow
Clima Control:
All settings are done with the Push & Turn Button
(PTB). By pushing the button you will enter the
set-up menu. An arrow will appear on the left side
of the display =>.
Setting the fan/box:
• Remove the plug of your Clima Control from
the outlet.
• Wait 10 seconds.
• Re-plug back into the outlet.
You will now enter the fan set-up menu:
=> Custom
Lemmens
Torin
Push or wait 3 sec
Place the arrow in front of your brand by rotating
the PTB. If you have a fan other than Lemmens or
Torin, choose Custom. Push the PTB to confi rm.
You will enter the fan menu automatically (see
further in this manual).
If you do nothing the Clima Control will
continue with the previous fan setting after
3 seconds.
Costum-menu:
Adjust Box to 10%
and push button
Please see manual.
• • •
The fan is not running or will run very slow. Rotate
the PTB until you feel that the fan is at 10% of its
maximum speed. This way, you can decide how
much power is needed for 10%.
Push the PTB and the following will appear:
Adjust Box to 90%
and push button
Please see manual.
• • • • • • • •
The fan is now running slowly. Rotate the PTB
slowly until the fan stops increasing speed. This
is the 100% speed. Rotate the PTB back until you
feel that the fan is at 90% of its maximum speed.
This way, you can decide how much speed is
needed for 90%.
Push the PTB to confi rm:
The box is now
adjusted.
Brand menu:
Select your brand and select your fan:
Select fan
1000-5000 m3
Push or wait 3 sec
The desired fan can be selected by rotating the
PTB. Your selection is set as default after a push
on the button. This fan setting will be used when
rebooting the Clima Control.
Fan reaction speed
On the display appears:
"Set the time between changing the power level of
the box" (between 3 and 30 seconds). If you push
the PTB again you will enter the set-up menu.
Set the time between
changing the power
level of de box.
5s
We recommend to choose al low reaction speed
for smaller areas (5 - 10 sec.), and a higher
reaction speed for larger areas.
It is possible to adjust the reaction speed if the
temperature remains to fl uctuate strongly with the
current settings.
If the temperature increases too often it is
recommandable to set a shorter delay time.
If the temperature decreases too often it is
recommandable to set a longer delay time.
Previous menu's are onle accesible after
booting the Clima Control.
There is no access to these menu's once the
Clima Control has entered the set-up menu.
To return, the Clima Control has to be
disabled for at least 10 seconds before enabling
again.
9