Publicidad
OVERVIEW
1
1. AC INLET and FUSE HOLDER
Use the supplied AC cord to connect the unit
to AC mains. Make sure voltage and frequency
stated and set on the unit comply with your local
AC supply. The fuse can be accessed by the
small drawer at the AC inlet. To change the fuse,
unplug the AC cord first, pull out the fuse drawer
and replace the fuse ONLY with a fuse of SAME
voltage and rating.
2. HEADPHONE REAR OUTPUTS (CH A to H)
Stereo (TRS) outputs suitable for driving
headphones. While headphones down to 32
Ohms can be connected, a higher impedance
type (> 60 Ohms) is recommended for lower
distortion at high output levels. These outputs
are in parallel to the front-side outputs (10).
Please note that if headphones are connected to
both front and rear outputs, the load impedance
will be half, so the headphones must have a
sufficiently high impedance.
3. DIRECT INPUTS (CH A to H)
Stereo TRS inputs (unbalanced) to allow a
direct input feed for a specific output channel.
The assigned source (12) will be disabled
automatically if a connector is inserted here, and
the direct input signal is played at the output
(2/11) instead.
2
3
4. MAIN INPUT R (Inputs 1 and 2)
Balanced input connector. This input is used as
the right channel input when the source is stereo.
The right channel is not be used when the source
is mono.
5. MAIN INPUT L/Mono (Inputs 1 and 2)
Balanced input connector. This input is used as
the left channel input when the source is stereo.
The left channel is used when the source is
mono.
5
4
5
Publicidad
