3. Push the release buttons at the sides of shaver head, take off the outer blade and clean it with the cleaning
brush.
4. After cleaning it install the outer blade and put on the protective cover.
Shaver parts replacement
1. Push the release buttons at the sides of shaver head and take off the shaver head.
2. Remove the outer knife net from the shaver head.
3. Replace the outer knife net.
4. Place the shaver head back at the product.
Replace inner knife head
1. Push the release buttons at the sides of shaver head and take off the shaver head. Hold both ends of the inner
knife head tightly and pull the inner knife head out of the shaver vertically. When you place the new inner knife
head, hold both ends of the knife head and insert the inner knife head until is has been fixed.
2. Attention: Do not loose the spring inside the inner knife head!
Correct disposal of this product
Do not store the product where it could fall into a water-filled tub or sink. The battery must be removed from the
appliance before it is scrapped. The appliance must be disconnected from the supply mains when removing the
battery. The battery is to be disposed of safely.
Warranty
For 24 months after date of purchase in respect of defects found - at our discretion - to be due to faulty
workmanship or material. Warranty is valid only with a complete, filled out warranty-card and receipt. There is
no guarantee on appliances found to be defective due to wrongful usage, disassembling or accidental breakage.
Warranty is not valid for damages resulting from defects.
In accordance with our policy of continual product improvement, we reserve the right to make technical and
optical changes without notice. The current version of this instruction manual can be found under www.arovo.com
This marking indicates that, throughout the EU, this product should not be disposed of
with other household waste. To prevent possible harm to the environment or human
health from uncontrolled waste disposal, recycle it responsibly in accordance with the
sustainable reuse of material resources. To return your device at the end of its useful
life, please use the return and collection system provided or contact the retailer where
the product was purchased. They will be able take the product for environmentally
safe recycling.
5