Technical Data - Marmitek DS90 Modo De Empleo

ADDING A WIRED SENSOR TO THE DOOR/WINDOW
SENSOR DS90
The DS90 Door/Window Sensor has a contact for an extra wired sensor. These sensors need
to be of type NC (normally closed contacts). There should not be any power on this contact
(potential-free).
1. Open the transmitter part of the DS90 by removing the screw.
2. Remove the wire bridge from the connection for the wired sensor (6).
3. Connect your sensor.
The wired contact has its own zone on the console. You can register the contact using the
procedure as described in your manual. To register the sensor, trigger the alarm of your wired
sensor while registering it.
☺ The setting of the MIN/MAX switch (entry delay) of the DS90 is valid for both the
magnetic contact and the wired sensor.

TECHNICAL DATA

Power : 2x AAA battery
Range: Up to 100m free field, up to 30m through walls and ceilings
Dimensions: 44x86x20mm
Frequency: 433.92 MHz
Environmental Information for Customers in the European Union
European Directive 2002/96/EC requires that the equipment bearing this symbol on the product and/or its packaging
must not be disposed of with unsorted municipal waste. The symbol indicates that this product should be disposed
of separately from regular household waste streams. It is your responsibility to dispose of this and other electric and
electronic equipment via designated collection facilities appointed by the government or local authorities. Correct
disposal and recycling will help prevent potential negative consequences to the environment and human health. For
more detailed information about the disposal of your old equipment, please contact your local authorities, waste
disposal service, or the shop where you purchased the product.
4 MARMITEK