Panasonic VIERA Serie Manual De Usuario página 74

■
Assembling the pedestal
●
Fix securely with assembly screws
●
Tighten screws firmly.
A
Bracket
Front
Base
■
Set-up
●
Tighten assembly screws
tighten them firmly to fix securely.
Rear view
Rear side
Arrow
mark
Base
(Image)
Work on a flat surface
Removing the pedestal from the TV
Be sure to remove the pedestal in the following way when using the wall hanging bracket or repacking the TV.
Remove the assembly screws
Lift the TV from the pedestal.
Remove the assembly screws
WARNING
Do not disassemble or modify the pedestal.
●
Otherwise the TV may fall over and become damaged, and personal injury may result.
Caution
Do not use any pedestal other than that provided with this TV.
●
Otherwise the TV may fall over and become damaged, and personal injury may result.
Do not use the pedestal if it becomes warped or physically damaged.
●
If you use the pedestal when it is physically damaged, personal injury may result. Contact your nearest Panasonic
Dealer immediately.
During set-up, make sure that all screws are securely tightened.
●
If sufficient care is not taken to ensure screws are properly tightened during assembly, the pedestal will not be strong
enough to support the TV, and it might fall over and become damaged, and personal injury may result.
When removing the pedestal, do not remove the pedestal by any methods other than the specified procedure.
(above)
●
Otherwise the TV and/or pedestal may fall over and become damaged, and personal injury may result.
Attaching the pedestal to TV
. (Total 4 screws)
A
Make sure that the bracket is
anchored before fixing the screws.
(Image)
(total 4 screws) loosely at first, then
B
B
Arrow
mark
Hole for pedestal
installation
bracket
from the TV.
B
from the bracket.
A
Accessories
Assembly screws (4 of each)
A
XSS5+16FNK
size (M5 × 16)
B
XYN4+F25FJK
size (M4 × 25)
Bracket (1)
Base (1)
7