Drive AQUAJOY SAVER Instrucciones De Funcionamiento página 8

How to remove your AquaJoy SAVER Bathlift
 Empty the water from the bath.
 Press and hold the Down button to lower the bathlift to its lowest position
 DISCONNECT THE HAND CONTROL!
 Fold the side flaps onto the seat
 Lift the seat section up, continue to lift the bathlift seat section until it is clear of the
bathlift base.
 To remove the base, lift the suction release bar at the back of the bathlift base
tilt the base forward.
 This will release the front suction cups and the base section can be lifted from the bath.
PLEASE NOTE: DO NOT use the suction release handle to lift the bathlift. Once the rear suction
cups are released simply lift the bathlift base out of the bath.
PLEASE NOTE: PLEASE ALWAYS ENSURE THE BLUE ACTUATOR LATCH & BLUE BRACKET ARE
ALWAYS FULLY ENGAGED / PRESSED IN PLACE / PIN IN PLACE.
Fig 4
Fig 6
(Fig
(Fig 6)
5)
Fig 5
(Fig
Fig 7
4)
(Fig 7) then
8