Troubleshooting - Joycare JC-240 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 21
CAUTION: If the transmitter is connected to the power adapter, the maximum transmission range
reaches 100 metres.
EQUIPMENT OPERATION TIPS
For some houses featuring steel wall reinforcements, a reduction in range may occur upon battery
operation. It is therefore highly advisable to keep the equipment connected to the power supply for
home use.
Both devices have a lower range when operating in inside - outside scenarios compared to inside -
inside ones. Therefore, it is highly advised to adjust the receiver volume to a level that allows clear
reception.
Should you experience interference on channel 1, please move the channel selector of both units
to channel 2.
IMPORTANT: Even when both units are tuned to different channels, if they happen to be placed within
a distance of 10mt or less of each other the reception may still be clear, providing a false impression
of proper functioning. Always ensure both devices are set to the same channel.
TROUBLE SHOOTING
PROBLEM
The green light indicator
does not come on
The transmitter emits
a strong and annoying
background noise
The receiver captures the
noises and sounds or atmo-
spheric discharges outside
your home
You hear a noise (very
intense), although you can
still hear the baby
POSSIBLE CAUSES
The equipment does not
power on
Both devices are too close
The volume on the receiver
is too high
A neighbour is using an
equipment similar to yours or
other wireless devices using
your own FM channel
The signal level is low
because of the location of the
room and the equipment
9
REMEDIAL ACTIONS
If you are using the power
adapter, make sure it is well
inserted in the socket and
the power adapter output
functions properly
If you are using batteries,
make sure they are properly
installed
Move the receiver at least
3 metres away from the
transmitter.
Turn down the receiver
volume
Change the channel on
both units
Use the transmitter with the
power adapter to increase
the signal strength.
Move the transmitter to
another location in the room.
Check the position of the
receiver

Publicidad

Tabla de contenido
loading

Tabla de contenido