Symbol QRG 68 Serie Manual De Instrucciones página 15

Q u i c k
Switching from 802.11 to Spring RF Protocol
(PDT 6842)
Note: The terminal boots up with the 802.11 RF protocol.
Perform the following procedure to switch to the Spring
RF protocol.
1. Boot up the terminal. The following prompt displays:
SOFTWARE UPDATE
Update?[y/n]:
2. Within four seconds, type the letter "y". If you do not type the
letter "y" within four seconds, the terminal boots up with the
802.11 RF protocol.
The next prompt displays:
RF PROTOCOL UPDATE
OPPORTUNITY
Update RF protocol
[y/n]:
3. Within ten seconds, type the letter "y". If you do not type the
letter "y" within ten seconds, the terminal boots up with the
802.11 RF protocol.
The next prompt displays:
RF Protocol
Currently 802.11
1. Abort update
2. Make pre-802.11
3. Make 802.11
Select[1,2,3]:
4. Select 2 to boot up with the Spring RF protocol.
R e f e r e n c e
13