Joyello JL- 976 PAPPERTUTTO Manual De Instrucciones página 13

It is advisable to add 10ml of water for the sterilisation function, as the cycle lasts
about 5-7 minutes and turns off when all the water has been evaporated.
After a maximum of 5-7 minutes, however, you have to turn the control knob to the
OFF position to complete the cycle, if you have inserted more than 10ml of water.
"HOME" MODE FUNCTIONS TABLE
Temperature WATER QUANTITY
on command 65 ml FOR BOTTLES OF MILK/ BABY FOOD JARS
dial 10 ml FOR STERILISATION
40°C KEEPING THE TEMPERATURE OF THE BABY BOTTLE WARM
When the orange light switches off, set the knob control
to OFF, unplug the plug from the wall outlet, wait half a
minute and then remove the baby bottle or jar
70°C RAPID HEATING OF BOTTLE OF MILK
OR JAR OF BABY FOOD
When the orange light switches off, set the knob control
to OFF, unplug the plug from the wall outlet, wait half a
minute and then remove the baby bottle or jar
FOR STERILISATION ONLY iadd about 10 ml of water
100°C
After 5-7 minutes, if the water evaporation cycle is not
finished, turn the control knob to "OFF", unplug the plug
from the wall outlet, wait half a minute, and then remove
the baby bottle and/or steam-sterilized accessories.
In this configuration, the product turns off only after the
water has evaporated from the tank.
The warning light in this function turns off only by turning
the control knob to "OFF".
WARNING: for the same functions in "AUTO" mode, the time necessary for the
same amount of water in the tank increases considerably, roughly doubling
compared to the time indicated in the table above.
WARNING: to heat baby food use the jar and lid supplied with the product.
13
GB