EXALTA EL-550 Manual De Instrucciones página 12

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 36
it after use since the proximity of water
presents an hazard even when the item is
switched off.
During use, make sure the power cord
is not in contact with the hot parts of
the appliance. Do not place paper (or
derivatives), fabric, rubber, wood, plastic or
other materials with low spark temperatures
inside the tank as they could be damaged
or create dangerous situations.
Avoid touching the hot metallic parts of
the appliance during use and in the few
minutes after is has been turned OFF.
Always unplug the appliance after use.
INSTRUCTIONS FOR CORRECT USE OF THE PRODUCT
Make sure the knob for turning is in the OFF position.
Place the can of wax in the well after having removed the protection.
Connect the wax warmer to the power supply. The LED will light up. Set
the knob on the maximum temperature by turning it to the right.
The time required to melt a can of wax and make it usable for the
application is about 40 minutes. When the wax in the can has reached the
optimal temperature required for the application, set the knob in order
to maintain the wax at a constant ready-to-use temperature to enable
further applications. (Set the knob on MED position)
If the wax is too hot, wait for it to cool down prior to proceeding with
the application. When the application is finished, set the knob on "0"and
unplug the power supply. The wax-heater can only contain 400 g cans or
the specific basket container for hot wax supplied.
Attention: Do not put the hot wax directly into the tank.
Important! The temperature positions indicated on the dial are merely
indicative and can vary according to the type of paraffin used.
12

Publicidad

Tabla de contenido
loading

Tabla de contenido