HON VL220 Instrucciones De Armado

Descargar este manual

(A ) Caster x 5PCS

(B) Base x 1PC

(D) Seat Plate x 1PC

Cover x 1PC

(E) Seat Cushion x 1PC

(F) Back Cushion x 1PC

(G) Left Armrest x 1PC

(H) Right Armrest x 1PC

(J) Screws for armrest inner

(I) Flat Washer x 14PCS

holes and seat plate D5/16" x

L1-1/10" X 6PCS

(K) Screws for seat plate and

(L) Screws for arms outer holes

back support D5/16" x L1-1/4" x

D5/16" x L1-3/4〞X 4PCS

4PCS

(M) Allen Wrench X 1PC

ATTENTION：Make sure all bolts and screws are

fully tightened before using chair. Lubricate all

moving parts and tighten all bolts/screws every 6

month or whenever needed.

VL220 Assembly Instruction

Step 1: Turn Base (B) upside down. Insert Caster (A) to Base

(B).

Step 3: Attach Left and Right Armrest (G/H) to Seat Cushion

(E) by using Screws (J) for inner holes, Screws (L) for outer

holes, Flat Washer (I) and Allen Wrench (M).

Step 5: Attach Back Cushion (F) to Seat Plate (D) by using

Screws (K), Flat Washer (I) and Allen Wrench (M).

Step 2: Insert Gas Lift with Telescope Cover (C) to Base (B).

Step 4: Attach Seat Plate (D) to Seat Cushion (E) by using

Screws (J), Flat Washer (I) and Allen Wrench (M).

Step 6: Put Seat/Back assembly to top of Gas Lift (C) by

aligning hole in center of Seat Plate (D). Complete.

Página 1 VL220 Assembly Instruction (A ) Caster x 5PCS (B) Base x 1PC Step 1: Turn Base (B) upside down. Insert Caster (A) to Base Step 2: Insert Gas Lift with Telescope Cover (C) to Base (B). (B). (C) Gas Lift with Telescope...
Página 2 ARTICLE : VL 220 INSTRUCTIONS D’ASSEMBLAGE VL220 Assembly Instruction Étape 2 : Introduire le vérin à gaz avec protection Étape 1 : Mettre le socle (B) à l’envers. Introduire la (A) Roulette x 5 PIÈCES (B) Socle x 1 PIÈCE...
Página 3 Instrucciones de armado de VL220 VL220 Assembly Instruction Paso 2: Inserte el cilindro de regulación de altura a gas con Paso 1: Invierta la base (B). Inserte la rueda orientable (A) (A) Rueda orientable x 5 PIEZAS (B) Base x 1 PIEZA...